Adjustable Anet A8 Sensor Mount

This part is to allow you to take the Anet A8 rear mount sensor and move it to the front when you convert to the E3d hotend. It allows the user to fine tune the sensor height adjustment. It is meant to be used with the customizable e3d mount. http://www.thingiverse.com/thing:2099577

I adapted the front e3d plate with the adjustable mount I found and will link later.

I am currently using skynet on my A8 and I'm working on fine tuning the design and the skynet setup.

For installation, I used hot glue to mount the sensor to the plate. It also used a 45mm m3 screw and m3 nut. for the spring, you can rob the spring from one of your clicky pens from the junk drawer.

This part has made adjustment of the hot end/bed gap so much easier.