Thingiverse
Adjustable bench vise
door Chaosmstr
3
Downloads
0
Likes
0
Makes
Fully printable small vise with moveable jaw.
Made this to hold circuit boards for soldering.
Quick adjust the jaw width, instead of cranking the handle over and over.
One washer inside gets glued to the screw shaft to keep it from pushing out.
Other washer to space handle off of the body.
Main body can be done at 20-30% infill.
Would suggest 100% for the rest of the parts.
File #3 needs supports, the rest can be printed without.
Made this to hold circuit boards for soldering.
Quick adjust the jaw width, instead of cranking the handle over and over.
One washer inside gets glued to the screw shaft to keep it from pushing out.
Other washer to space handle off of the body.
Main body can be done at 20-30% infill.
Would suggest 100% for the rest of the parts.
File #3 needs supports, the rest can be printed without.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!