Slicer Discord
Adjustable Bicycle Flashlight Holder – 3D-Druckmodell von Thingiverse Thingiverse

Adjustable Bicycle Flashlight Holder

10 Downloads
4 Likes
0 Makes
Zum Modell
I created this flashlight mount that is adjustable. I would like to install a flashlight just about anywhere and be able to angle the flashlight forward and you couldn’t do that with many of the rigid flashlight mounts out there. This one has teeth to grip the bike and the light. I suggest using electrical tape or blown inner tube as the rubber to grip the mount. The panduit holes are dedicated so they don’t bunch up in the center.

The screw used is a #8 size nut and .5 inch to .75 inch bolt from any hardware store. Scale up for metric. Recommend using a lock washer. Built in hex geometry to hold in place the Nut. If it doesn't fit well, use the bolt to screw hex nut into place. Tight fit but even better.

Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen