Slicer Discord
Adjustable Bottle-Dripper Irrigation Spike v2 – 3D printable model from MakerWorld MakerWorld
Garden

Adjustable Bottle-Dripper Irrigation Spike v2

by Henon · Garden
489 Downloads
61 Likes
342 Makes
Go to Model
Adjustable Bottle-Dripper Irrigation Spike for EU Plastic Bottles (v2)This is an improved design of my original Adjustable Bottle-Dripper Irrigation Spike The Bottle-dripper is designed with a water-tight screw-lid for EU plastic bottles (PCO 1881) and is one of the only bottle drippers on this platform that is not leaking from the bottle cap. Also, it can be adjusted to drip very slowly, because what good is an irrigation bottle that drips out in an hour? With the adjustment screw the drip speed can be reduced to one drop per several seconds so that a large bottle can hold up to two days. If the flow is too high you can reduce it by placing a bit of cloth in the screw-hole and tightening the screw with it. The spike is designed to hold even 2L bottles but you may want to bind them to a stake to avoid them from tipping over. Don't forget to make a tiny hole in the top (the bottom of the bottle) to let air in, otherwise either the resulting vacuum will crush the bottle or the flow w
Category
Garden
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA, Polycarbonate
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection