Slicer Discord
Adjustable Cell Phone Stand – Modelo 3D imprimible de Thingiverse Thingiverse

Adjustable Cell Phone Stand

por bxh
22 Descargas
19 Likes
0 Makes
Ver Modelo
Adjustable height cell phone stand with storage compartment for stand for portability. See video below (it's neat :-), well I think so :-)).

The cell phone is intended to sit vertical or horizontal. If sitting horizontal you can plug the charging cable in, but not when vertical as there is no pass through for a charging cable (this was by design as it was made for what I needed). There are 5 slots in the base that the stand can be inserted into that will change the angle (height) of the stand depending on which slot is used. There are 3 non-slip pads to reduce sliding of the base, stand and device.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección