Thingiverse
adjustable filament holder
von Joshkiste
0
Downloads
0
Likes
0
Makes
This is a remix of the TUSH++ by cdeerinck with a few more tweaks:
- bigger Spool holder.
- detent so it will not move around.
usable with or without screws (M3)
- Keep the two sides of each holder together
- (use screws)
- Keep two holders a specific distance apart for different spool widths
- Allow you to keep more than one holder next to each other by interlocking them
other holder sizes will be added!
If any new versions or adjustments are needed, please leave a comment.
- bigger Spool holder.
- detent so it will not move around.
usable with or without screws (M3)
- Keep the two sides of each holder together
- (use screws)
- Keep two holders a specific distance apart for different spool widths
- Allow you to keep more than one holder next to each other by interlocking them
other holder sizes will be added!
If any new versions or adjustments are needed, please leave a comment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
