Thingiverse
Adjustable laptop stand
von denyok
6
Downloads
9
Likes
0
Makes
This is a vertical stand for laptop.
My laptop (Nitro 5 ) has a DC conntector and two ducts in rear of case. The stand models I found was not designed for this configuration and I had to design own solution.
The second problem was the stands I have found have fixed size . This stand can be adjusted by thickness from 0 to about 37 mm.
I use M4 inserts and screws to assemble stand parts. I printed pads used TPU filament because I had not got appropriate thin rubber sheet but TPU was.
My laptop (Nitro 5 ) has a DC conntector and two ducts in rear of case. The stand models I found was not designed for this configuration and I had to design own solution.
The second problem was the stands I have found have fixed size . This stand can be adjusted by thickness from 0 to about 37 mm.
I use M4 inserts and screws to assemble stand parts. I printed pads used TPU filament because I had not got appropriate thin rubber sheet but TPU was.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!