Thingiverse
Adjustable mini-tripod
door JasonMBryant
37
Downloads
31
Likes
0
Makes
If your camera fits in one pocket, then your tripod should fit in the other.
Sometimes I want to take a picture of something small (like an item I just printed), but the light is too low to take a good picture at night without a tripod. I want to be able to put it on the table and aim down, so I made this little tripod. Also, sometimes I am somewhere neat like a park, and I want a picture from the ground with the camera aimed up. So I made it adjustable.
You can aim the camera between 40 degrees up and 40 degrees down. It's small enough that the parts can fit in your pocket. There's a little ring on the basket that you can tie the pin to.
The screw is based on the Camera Tripod Screw (1/4" - 20 UNC): http://www.thingiverse.com/thing:213425
Sometimes I want to take a picture of something small (like an item I just printed), but the light is too low to take a good picture at night without a tripod. I want to be able to put it on the table and aim down, so I made this little tripod. Also, sometimes I am somewhere neat like a park, and I want a picture from the ground with the camera aimed up. So I made it adjustable.
You can aim the camera between 40 degrees up and 40 degrees down. It's small enough that the parts can fit in your pocket. There's a little ring on the basket that you can tie the pin to.
The screw is based on the Camera Tripod Screw (1/4" - 20 UNC): http://www.thingiverse.com/thing:213425
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
