Thingiverse
Adjustable Phone/Tablet Stand
door Copadub
13
Downloads
10
Likes
0
Makes
This is a remix of the "Phone Stand by GoAftens.
My remix has a bit more of an addition to the design than others that have been made. I modeled rounded legs for the stand, which allow it to move back and forth in the Stand Holder, allowing adjustable viewing angles. I thought of this idea after a year of using the stand. If I was standing, it would be more difficult to see the screen vs sitting. I would always be propping it up on books and such, but that made the stand unstable and it wasn't a good solution. With the new idea and the wonders of 3D modeling and printing, I now have the stand I have imagined. I also extended the area where the phone sits, to accommodate a case or a thicker device.
This is one of my first designs so let me know what you think!
(I used Cura to Slice this)
PRINT SETTINGS:
- Supports only on the "Phone Stand"
-For "Phone Stand Holder" use "Adaptive Layers". (Set Layer Height to 0.2mm) Set the Maximum Variation to 0.1mm. This
My remix has a bit more of an addition to the design than others that have been made. I modeled rounded legs for the stand, which allow it to move back and forth in the Stand Holder, allowing adjustable viewing angles. I thought of this idea after a year of using the stand. If I was standing, it would be more difficult to see the screen vs sitting. I would always be propping it up on books and such, but that made the stand unstable and it wasn't a good solution. With the new idea and the wonders of 3D modeling and printing, I now have the stand I have imagined. I also extended the area where the phone sits, to accommodate a case or a thicker device.
This is one of my first designs so let me know what you think!
(I used Cura to Slice this)
PRINT SETTINGS:
- Supports only on the "Phone Stand"
-For "Phone Stand Holder" use "Adaptive Layers". (Set Layer Height to 0.2mm) Set the Maximum Variation to 0.1mm. This
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!