MakerWorld
Other House Models
Vai al Modello
Adjustable Picture Hanger
41
Download
9
Likes
41
Makes
Simple wall hanger for canvases. Mounts on a single nail or screw and allows small left/right adjustment for easy centering. Includes a center notch to help position it during installation. Uses less than 6 g of filament. Recommended Print Settings Layer height: 0.28 mm Infill: 100% No supports needed Hardware Used 2 self-tapping screws 3 × 15 mm Installation Find the center of your canvas/frame. Use the center notch to align the hanger. Mark the screw positions. Pre-drill small holes in the wood frame using a hand pin vise or small drill. Attach the hanger with two 3 × 15 mm screws. Place the wall nail into the desired tooth slot. Slide left or right until perfectly centered. Notes Best used with lightweight to medium-weight canvases. Pre-drilling helps avoid splitting the wood. For maximum stability, add small rubber pads to the bottom corners of the frame.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
