Adjustable Speaker Stand (No Hardware required)

Adjustable Speaker Stands These adjustable speaker stands are designed for a range of different sized speakers in different positions, above or below you.They can be adjusted up to about 20 Degrees or just flat. The hinge is 'Print In Place' and is very strong. Total length is 200mm and width is 100mm to 160mm wide. The width is selectable by choosing the appropriate sized bar (100mm to 160mm). I can do a bigger range of sizes, but this should be good to start off. No extra hardware is required (Other than optional feet)Circular recesses are on the top and bottom for adding on Self-Adhesive feet if you want more grip on the surface it's on. A few blobs of bluetack does wonders too for this. Each stand uses roughly 250grams of Filament and takes around 7 hours. They are strong, and can easily hold a a few KG of speaker. I'd reccommend PETG for this. Boost Me