Thingiverse
Adjustable Woodworking Clamping System
von jdegenstein
85
Downloads
71
Likes
0
Makes
REVISION 201120:
- Reduced the thickness of all parts to 1/2 inch for the cams and fence and 1-inch length for the pins.
- Added labels to the Left and Right cams
- Other miscellaneous changes
- Deleted old thicker version
REVISION 201114:
- Added a 3D printed pin to the the OpenSCAD source and STL. Has 3/8" outer diameter and is approx. 1.75" long.
REVISION 201113:
- Fixed an issue with the CAMS where the STLs had some corrupt geometry. This was corrected starting with the SCAD/STLs.
REVISION 201112:
- Original release
Inspired by the Meyer Clamping System and a video from Rex Krueger about it:
https://www.youtube.com/watch?v=IPlWgEeBHlE
This system is designed to be used with a square grid of 3/8" holes on 2" centers. ~~I did not bother designing the pins since I am not sure 3D printed pins would be strong enough.~~ It would probably best to use hardwood or metal pins
I am releasing this as a work-in-progress to the community because I have NOT pri
- Reduced the thickness of all parts to 1/2 inch for the cams and fence and 1-inch length for the pins.
- Added labels to the Left and Right cams
- Other miscellaneous changes
- Deleted old thicker version
REVISION 201114:
- Added a 3D printed pin to the the OpenSCAD source and STL. Has 3/8" outer diameter and is approx. 1.75" long.
REVISION 201113:
- Fixed an issue with the CAMS where the STLs had some corrupt geometry. This was corrected starting with the SCAD/STLs.
REVISION 201112:
- Original release
Inspired by the Meyer Clamping System and a video from Rex Krueger about it:
https://www.youtube.com/watch?v=IPlWgEeBHlE
This system is designed to be used with a square grid of 3/8" holes on 2" centers. ~~I did not bother designing the pins since I am not sure 3D printed pins would be strong enough.~~ It would probably best to use hardwood or metal pins
I am releasing this as a work-in-progress to the community because I have NOT pri
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!