Thingiverse
Adjustable Z-End Stop
von onepointdiy
3
Downloads
9
Likes
0
Makes
This is only for the suitable Mendel.
if your Mendel's X-end of the motor side has a M3 hole and a recess of M3 nut, You can use this. (see photo)
* approx 75 mm Full Thread M3 screw and some M3 nuts are needed.
if your Mendel's X-end of the motor side has a M3 hole and a recess of M3 nut, You can use this. (see photo)
* approx 75 mm Full Thread M3 screw and some M3 nuts are needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!