Slicer Discord
Adjustable Z-Endstop - Anet A2 – 3D-printbaar model van Thingiverse Thingiverse

Adjustable Z-Endstop - Anet A2

door MrTB
22 Downloads
6 Likes
0 Makes
Model downloaden
Using Freddy_Fox's design, I had to adjust the mountings to accommodate my setup that uses a custom version of Olev's Single Stepper Dual Z setup. I needed to move the set screw mounting to another location on the ZX-axis Gantry. I decided on mounting the set screw holder on the inside of Z screw since it did not interfere with the X carriage. The relay holder also had to be extended in two directions to align properly with the set screw. I applied heat to the M5 nut to secure it into set screw holder. It is not necessary to do this since inserting the nut is already a snug fit.

I used M5 screw and nut for the set screw.
You can use (up to) M5 screws and T-Nuts to secure it to the frame.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie