Slicer Discord
Adsb Moxon Antenna – Modèle 3D imprimable de Thingiverse Thingiverse
Adsb Moxon Antenna – Bild 1 Adsb Moxon Antenna – Bild 2 Adsb Moxon Antenna – Bild 3 Adsb Moxon Antenna – Bild 4 Adsb Moxon Antenna – Bild 5 Adsb Moxon Antenna – Bild 6
Electronics

Adsb Moxon Antenna

56 Téléchargements
46 Likes
2 Makes
Voir le modèle
Most of the ADSB feeders / enthusiasts are not being able to put up antennas on the roof covering the whole 360 degree. But as a go to antenna, most of the time ground plane vertical antennas are being used at first and then co-linear coaxial antennas are being advised as an improvement over ground planes. If you have the ability to cover ~360 degrees, using these antennas is off course good for staying omni-directional. So this way you can get frames from all directions.

But many enthusiasts are actually using them sticking out from a window - a balcony or sometimes even indoors near to a window. On those cases moxon is a much better antenna alternative compared to those omni vertical antennas as:

- Closed loop type antennas get less noise (QRM) compared to vertical omni antennas which improves SNR and that means more decodes even without a filter and Lna. You can use more gain on the SDR without hurting the SNR.

- It has the gain directed mostly on the forward direction so
Catégorie
Electronics
Source
Thingiverse
Publié
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection