ADX5 Custom Light Bar

FLASHFORGE AD5X Custom Light Bar JBR001@user_2560563635 This is a custom light bar for the Flashforge ADX5. It attaches to the under rail where the touch screen ribbon cable runs with 4 6x3 Magnets. Supplies: - Printed Light bar 1 or 2 Note: if printing 1 ensure you print the one with the magnet holes facing you and the wire hole to the LEFT, printed in High Temp PLA, PETG or PLA if you will not use an enclosure. - 6x3 Magnets (Qty 8, 4 for each light bar) - Mini micro JST 2.5 male connectors at the end of the light cable. (Qty 2 with one for each side, or just 1) - 3D Printer Mainboard Y Splitter JST SM 2 Pin Motherboard Cooling Fan Cable 2 Pin Plug Male and Female Connector Adapter for 3D Printer. (Qty 1/None) - 24/2 Core for LED Lighting, Outdoor Low Voltage Extension Cable at the terminal hole on each end (use a 5/32 drill bit to clean hole for the cable. (Qty 1, 10" length for right side and 1, 15 inch length for left side or for single use 15 inch length for right side only)