Thingiverse
AED Sign
by tschetschpi
6
Downloads
5
Likes
0
Makes
A wall sign for an AED at my work. I used an M600 command to change filament at a layer just above 5mm.
It's meant to print two of the signs and then glue them back to back, then glue into the bracket. You can drill holes in the bracket to mount to the wall or use a double sided tape since this isn't that heavy.
Figured I'd share this since I couldn't find anything like it on any 3d printing site.
It's meant to print two of the signs and then glue them back to back, then glue into the bracket. You can drill holes in the bracket to mount to the wall or use a double sided tape since this isn't that heavy.
Figured I'd share this since I couldn't find anything like it on any 3d printing site.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!