AFA Deburring Tool Multibin Holders for Multiboard

This is yet another AFA Deburring Tool holder, designed for the Multiboard system. It is remixed from the ‘plate snap’ which I believe is designed for the Multibin plates and not necessarily the bins themselves, however it snaps tightly into a 1x1 Multibin. I recommend using a 1x1x1 Multibin so the blades bottom out and stick up the amount my photos show, but you could use up to a 1x1x2 comfortably. This model prints with under 8g of material in less than a half hour. Note: If the blade holes print too tightly for your blades and you don't have needle files to ream them, you can slice it with a positive “X-Y Compensation” value to slightly increase the size. I would not recommend going past about .05-.1mm on this value if you use it at all. I wanted to make my own of this specific design because I wanted one that would interface with a bin without needing the ‘click top’ bin insert. I considered using a Multibin Insert but it uses more plastic and is less versatile than a top, and when