Afinibot A1 platform

A little introduction of Afinibot A1. This is my first printer. It is very easy to build. The printer looks like any rostock mini, but the geometry is different from standard rostock mini. I only realized it after I compare the measurement between the 3d model of a standard rostock mini. If you had this printer and flashed other standard firmware to this machine, good luck to you. I do not have the original firmware for this printer.

This is a great DIY kit, as I took about 7 hours to build it.
Compare to other DIY kits, I notice other kits building time may took up to 2 days.

I broke the original platform and I find this more useful then the original platform. Hope some one can use this part and upgrade their Delta 3d printer.

I have been using this together with other hot end attachment.

You can use the following part here.

http://www.thingiverse.com/thing:966912
http://www.thingiverse.com/thing:903872