Thingiverse
Air Boot Dryer
von PrintFail
12
Downloads
14
Likes
0
Makes
This is a simple boot dryer that works using an old CPU cooler fan.
It has built-in supports for the vertical ducts. No need to add supports (it would be impossible to remove anyway).
Printed using PLA, 4 perimeters for added strength.
It has built-in supports for the vertical ducts. No need to add supports (it would be impossible to remove anyway).
Printed using PLA, 4 perimeters for added strength.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!