Air Purifier

This is a a 4-piece 3D printing "clone" to a Levoit Mini Air Purifier from Amazon
https://a.co/d/4hXKRhR
With the cost of all the pieces, it costs roughly $25 in comparison to the $50 Levoit Core Mini. Another change to the Levoit model is that this uses a linear compressor that sucks air from the top and filters through the inside and out. The Levoits suck air through the outside of the filter and blow air straight up. I find my model disturbs the air less this way.

Assembly is pretty straight forward. The enclosure has two holes that line up with the motor. The screws i used are flat-bottom instead of V-shaped. They can be torqued pretty good without warping the PLA enclosure. Depending on your settings, you may have to hammer the turbine onto the motor or glue the turbine. I found my settings worked great. It was a very tight fit. I added a small test square to test your settings. You may need to adjust your z-offset or line width. The test squre has a 1.325mm hole not 1,325mm.