Slicer Discord
air tool air diffuser and deflector. – 3D printable model from MakerWorld MakerWorld
Other Tools

air tool air diffuser and deflector.

1 Downloads
2 Likes
0 Makes
Go to Model
I hate the wine of a die grinder, and rear exhaust is the worst. So for my work usage, I created this add on part that goes over the end of the grinder where the air exhaust comes out. On its own, it will direct the flow to the side, and can be rotated for user preferred direction of exhaust as you work.If you want to quiet the tool down, stuff the end of this with some sort of open stuffing. My Stuffing of choice has been brown scotch bright, I find its open enough to let most air though easily, while dampening the sound. Its a balancing act though, the more/tighter you pack it, the more sound will be absorbed, but at the cost of RPM, so its worth starting lower and adding more till you achieve your desired effect. An o-ring is helpful between this cap and the inner diameter of the grinder if you experience to much air/sound leakage at that point. This size was designed around a wespro die grinders with the larger handle diameter, but will fit other brands as they seem to be the same
Category
Other Tools
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
ABS
Min. bed size
50 mm (Small)
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection