Thingiverse
Air Tunnel Patch
by dpvue
2
Downloads
2
Likes
0
Makes
Update 1: For a better approach, check this out: https://www.thingiverse.com/thing:4352377
The original design is great and I appreciate the effort the author put in it. However, in my opinion, the air tunnel/room is too large and not separated by the rest of the case. Thus, the SDS011 sensor fan is not able to create vacuum and absorb fresh air from outside, but it rather takes air from the case which acts as a buffer zone.
By this patch, I already noticed an improvement of the real-time PM readings (in the original design, there were some delays when comparing the readings towards a Netigo sensor (an improved version of Luftdaten.info).
Besides this, I hope to improve the temperature readings, but I'm not expecting miracles in this respect. A better solution would be a BME 280 sensor placed in an attached enclosure to the OBO case. The designers of Netigo sensors use with success a reduction M16 - M20 / and a blanking plug with a simple hole in the middle.
The original design is great and I appreciate the effort the author put in it. However, in my opinion, the air tunnel/room is too large and not separated by the rest of the case. Thus, the SDS011 sensor fan is not able to create vacuum and absorb fresh air from outside, but it rather takes air from the case which acts as a buffer zone.
By this patch, I already noticed an improvement of the real-time PM readings (in the original design, there were some delays when comparing the readings towards a Netigo sensor (an improved version of Luftdaten.info).
Besides this, I hope to improve the temperature readings, but I'm not expecting miracles in this respect. A better solution would be a BME 280 sensor placed in an attached enclosure to the OBO case. The designers of Netigo sensors use with success a reduction M16 - M20 / and a blanking plug with a simple hole in the middle.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!