Thingiverse
Air-Up BottleCap (Fixed)
von CoolMan96
4
Downloads
1
Likes
0
Makes
Bottle Cap which can slot an Air Up Pod, with a lock built in. (Never buy an Air Up bottle again!)
1) Screw the Air Up Bottle cap onto your bottle.
2) Put the Air Up pod in the slot at the top.
3) Place the lock (rectangle thingy) as far as it can go inside the slot located near the narrow end of the Pod Slot.
4) Enjoy!
1) Screw the Air Up Bottle cap onto your bottle.
2) Put the Air Up pod in the slot at the top.
3) Place the lock (rectangle thingy) as far as it can go inside the slot located near the narrow end of the Pod Slot.
4) Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!