Airbrush from Marker (Copic)

Inspired by the official Copic Airbrush kit, this tiny little print is more compact to bring with you, and costs 20 cents instead of 45 euro!

Check out the full story behind this design at my website, Tinkerworks.nl

After a dozen design iterations, it's working perfectly with just about any marker- Copic, Promarker, Twinmarker, random permanent markers, whiteboard markers, .....

Slide your marker in from the rear, and blow trough the hole. An airbrush-like spray pattern should appear on your paper.
Don't use the clip from the side- just slide it from the rear.


Print settings:
Print it with the hole flat to the printbed. The clip needs some supports, the rest should print fine without any. Materials, layer heights, etc shouldn't matter too much.