Airbrush Hose Guide

This is another item I needed to create in my ever evolving pursuit of the perfect airbrushing setup! (Hence the unfinished plywood currently!) It was made to be able to route the airbrush hose away from my chair and not get tangled up in the armrests. Two size 4 screws were used so you will need to just use the right length for the material you are screwing into. No special parameters I just did it with 4 walls and 25% infill. It was printed it flat on the build plate and just did a little tidy up of the hole afterwards. I hope this helps someone with their setup too, many thanks!