AirConception Main Switch Mount v2

This is a part I made for my Air Conception Tornado 250 E-start Paramotor.

I use a 22 inch XT-60 extension to relocate the battery to the left harness pocket for easy access and changing.

My Main (on/Off) Switch failed yesterday and when replacing it immediately realized a small panel point would be a great improvement. The junction of the horizontal and vertical frame pieces seemed the ideal location where it could easily be secured with tiptoes without being in the way of the cage tensioner.
This design incorporates the 5 degree offset the vertical frame tube on the Air Conception has. The angle between the vertical and horizontal frame tubes is approximately 85 degrees.


Designed to be held to the frame with three zip ties, there's a 30 x11 mm cutout for the Main Switch body.

Update: 09/02/20 : Redesigned the panel to fit flush between the vertical and horizontal frame pieces on the left side of the parameter. It should be easily found by feel.

Future improvement