Thingiverse
Airgap drain
por beemee
6
Descargas
4
Likes
0
Makes
For the installation of my water softener I needed an airgap between the softener and the sewer.
An 1/2" hose wil fit on the top whit an hose clamp.
The outlet is customizable an will fit in to an 40mm drainpipe
The airgap is made with two parts and printable without support. The two parts fits snugly together and can eventually glued together with some CA glue
Update v2: The funnel part was a bit to small, but in the scad file is it now customizable
An 1/2" hose wil fit on the top whit an hose clamp.
The outlet is customizable an will fit in to an 40mm drainpipe
The airgap is made with two parts and printable without support. The two parts fits snugly together and can eventually glued together with some CA glue
Update v2: The funnel part was a bit to small, but in the scad file is it now customizable
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!