Airless Basketball

THIS WILL BREAK IF PRINTED IN PLA, PETG, ABS OR PA! IT WILL NOT BOUNCE IF PRINTED IN TPU! This should be printed in any of the following filaments: BIQU PLA-HR DUDV2 PLA-B Splat Sting 3D's FPLA+ This is my most advanced ball yet. When printed it should weigh in at 620g and has a bounce of about 95% of a standard basketball. I have uploaded single (H2D, X1C, P1S & A1) and dual colour (H2D only) versions. Please make sure to: Use a .6mm nozzle - this increases the bounce and durability of the ball Dry your filament Apply magnets to the brim as shown in the images below after the nozzle clears the height of your magnets. I would also recommend doing this to the purge tower for dual colour print Commercial licenses available on request - drop me a message