Thingiverse
Airsoft Threaded Suppressors
door enone
1.4k
Downloads
1.1k
Likes
5
Makes
Finally got the flash hider off my JG p90 to measure the threads and decided to make a suppressor/silencer in blender. I made three of them with 14mm negative threads so it will fit most airsoft guns. The sizes are 30x80mm, 38x80mm, and 38x120mm and I also made a threaded adapter to fit airsoft pistols. I have only tested it on the p90 and i'm planing to test it on other airsoft guns later. Print with no support and use standard print height 0.2mm. Tested the 38x120mm suppressor today and had some lower than normal shots. Upon checking the suppressor there was some wear from the airsoft bbs making contact with the suppressor. So i made a new version of the 38x120mm with a wider opening by about a couple of millimeters. The smaller 30x80mm did not have any problems.
Update: Tried the adapter on a WE 1911 that had a threaded barrel with the orange tip pulled off. It didn't work due to size and further research revealed that the pistol threads are 11mm positive thread. Just posted the p
Update: Tried the adapter on a WE 1911 that had a threaded barrel with the orange tip pulled off. It didn't work due to size and further research revealed that the pistol threads are 11mm positive thread. Just posted the p
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
