Airtight SAMLA Container Lock
door Elitail
59
Downloads
52
Likes
0
Makes
IKEA SAMLA is perfect container for 3D printing filament, though it is not airtight. Only two of these clips will help! This ultimate design pushes container lid hard towards container so it is firmly closed. It can be used for filament storage as for other applications too.
https://youtu.be/EI7NPZbnfQI
Any plastic can be used to print these clips. I have used PLA.
Best position to print - put these clips on their side and enable supports.
To assemble two of these clips you will need:
1. Two screws M5 x 60
2. Two M5 nuts
Optional:
If you want to fix clip to container lid, you can use:
1. 5mm drill bit
2. Four screws M5 x 15
3. Four M5 nuts
Or you can use double sided tape
https://youtu.be/EI7NPZbnfQI
Any plastic can be used to print these clips. I have used PLA.
Best position to print - put these clips on their side and enable supports.
To assemble two of these clips you will need:
1. Two screws M5 x 60
2. Two M5 nuts
Optional:
If you want to fix clip to container lid, you can use:
1. 5mm drill bit
2. Four screws M5 x 15
3. Four M5 nuts
Or you can use double sided tape
Elitail publiceert ook op
34 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!