AirVersa AP2 Wall Mount

I printed this with 4 outer walls and 30% infill and it is probably way stronger than it needs to be and works very well.

I designed the hooks to be a nice and tight press fit into the vents so that it would stay securely mounted so it might take a little wiggling to get it on there but it will hold tightly.

When attaching it to the wall it is easiest to mount each bracket and then slot the machine in. The hole to hole mounting width is 220mm and vertically is 96mm. I used some #8 drywall anchors and wood screws

Make sure to print the mount flat on its outer side so that the hooks are pointing straight up.

The small hooks that slot into the vents on the side of the unit are the only parts that need support.

I printed the screw caps out of TPU so that they could more easily press fit into the holes but you could always adjust the tolerance on them and make them out of PLA