Thingiverse
AK barrel Vise
von pdthein
0
Downloads
2
Likes
0
Makes
This is only one half, so 2 are needed. There are recesses to add magnets. My barrel was .571in in diameter so I made this to .5in. This fits right between the front sight base and gas block on an AK103, AKM, AK74, ect. I printed this to clamp down my barrel to fix my canted sight block
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
