Thingiverse
Akatsuki LED Lamp
von tomo3dprint
1
Downloads
12
Likes
0
Makes
I printed in PLA, no problems so far.
No Support required.
These are 3 parts to make it easy to print and change colors.
Print the top+base top at the same time.
I bought the LEDs on EBay for $6.
LED Link: https://www.ebay.com/itm/405433351939
You’ve got two parts that snap together perfectly without glue, but if you want to make it extra secure, you can glue them. The LED I got already has adhesive, so sticking it in place is super easy. There’s also a hole in the back of the model for the wires to go through.
No Support required.
These are 3 parts to make it easy to print and change colors.
Print the top+base top at the same time.
I bought the LEDs on EBay for $6.
LED Link: https://www.ebay.com/itm/405433351939
You’ve got two parts that snap together perfectly without glue, but if you want to make it extra secure, you can glue them. The LED I got already has adhesive, so sticking it in place is super easy. There’s also a hole in the back of the model for the wires to go through.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
