AKK Micro HD AIO Camera Mount

Simple mount for an AKK AIO camera that can be placed on almost any rc car. was made for a JC Concepts 1/10 scale f-250. Has holes for using 25mm m3 hardware to mount. a rubber band to kinda hold the camera in place. use a couple of m3 washers or anything else to shim it out on one side to get the camera level, depending on where your mounting it. Make sure you print this using PETG, PA, or maybe ASA as all VTXs are going to get too hot for something like PLA. I have added vent holes to try to keep the temp down and I haven't had any overheating issues running my truggy around. I use a separate battery for running the camera but I am pretty sure you could just wire it into VBAT.