Thingiverse
AKM Wire Stock
von Grapist
1
Downloads
0
Likes
0
Makes
# Requirements:
- 1/2" Steel tube (or other material of same diameter)
- Any 3/4" long countersunk screws, if you want to be fancy then tap it, I just used self tappers
- *(For V2 stock grab some TPU for buttpad)*
Bend the tube however you like, and make them whatever length you like, I don't have any exact instructions unless you have a mandrel bender
- 1/2" Steel tube (or other material of same diameter)
- Any 3/4" long countersunk screws, if you want to be fancy then tap it, I just used self tappers
- *(For V2 stock grab some TPU for buttpad)*
Bend the tube however you like, and make them whatever length you like, I don't have any exact instructions unless you have a mandrel bender
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!