Aldi Mower Fuel Cap

Using my brand new Aldi mower for the second time, I noticed that while mowing, the fuel cap had come off and was hanging by the cord. Upon inspection, one side had broken off (the one with one of the 2 lugs), and after that, it wouldn't stay on properly any more. I thus created this mower cap replacement.

It fits an Aldi mower where two lugs are used to secure the cap after it is pushed on and turned by 30 degrees.

After searching the web for filaments that are fuel safe, I decided to use Taulman 645 nylon for this job. Apparently common materials like ABS, PLA, etc. are prone to deterioration from fuel. I have not tested this, so I can not say for certain about other materials failing, but the nylon is working very well and seem unaffected.

If you are an expert at nylon printing, use your normal settings and go for it. If you have had limited success in the past, and are unsure of how to get the best results because you don't use nylon regularly, I have found the follow