Aleph Objects Clamp X-ends

**NOTE** 1/31/2012: We've updated the design by making the clamps a bit tighter. We found that the smooth rod grooves had a very tight tolerance and would not clamp the rods tight enough in some cases.

This is a small update to the AO X-ends. The only major change is the bushing mount wall is beefed up good bit. The clamps are the same but have been uploaded here for ease of downloading the parts.

Wanting to move away from the cast x-ends but also liking the clamp style, we designed some new ones to work with the boltable PLA bushings. These are interchangeable with the standard Prusa or cast Clonedel x-ends.

This x-end set calls for a little extra hardware, but no glue and the ability to change out bushing easily makes up for it.

Hardware:
x8 M3 20mm SHCS
x8 M3 12mm SHCS
x24 M3 washers
x16 M3 Nyloc nuts (or regular nuts)
For the idler
x1 M8 30mm SHCS
x1 M8 Nyloc
x2 M8 washers
x2 Fender washers
x1 608 bearing

These x-ends use the boltable PLA bushings rather th