Alesis DM10 Module Mount Arm

This Mount arm allows you to move the mount from the cross bar to the leg support.
my print came out fine and works great. if I needed to reprint again I would change the module mount hole to 9.75 and sand to fit. I did do the print test with PLA, then ended up using PETG.on the actual print. I printed this laying down, hole opening up. only needs a min. of supports where the shaft goes into the frame mount. set random line changes otherwise you will end up with a weak point.

I suggest printing the test file first.

Module mount hole #1 r=9.75
used in my file. > #2 r=9.8
#3 r=9.85

stub for mount #1 10.75/10.75
used in my file. > #2 11/11
#3 11.25/11.25

Test Print:

// Mod Test Hole 1 : r=9.75
difference() {
translate([0,0,0]) cylinder (h = 5, r=13, $fn=100);
// r= inside hole size
translate([0,0,0]) cylinder (h = 26, r=9.75, center = true, $fn=100);}