Slicer Discord
Alien Hand – Modèle 3D imprimable de MakerWorld MakerWorld
Other Toys & Games

Alien Hand

11 Téléchargements
31 Likes
2 Makes
Voir le modèle
This is what you might call ade-ssistive device - it takes two perfectly good hands to operate one rather feeble (although slightly sinister) one. Inspired by various tentacle designs (http://www.thingiverse.com/thing:6986, http://www.thingiverse.com/thing:10337, http://www.thingiverse.com/thing:206231), each finger prints as a single piece with 12 flexible sections and can be configured in 8,388,608 (give or take) different ways.I've got this version configured as two 4-DOF (degree of freedom) fingers and one 2-DOF thumb. You can actuate particular flexures in a finger by running the tendons through holes in the outside corners, and not activate other flexures by running the tendons through holes in the center. I've biased all three fingers backwards with tendons running along the back side, and that are then attached to rubber bands.And finally, I've mounted the fingers on a palm-gripped platform that lets you use all 10 of your fingers to operate all 10 degrees of freedoms. As you c
Catégorie
Other Toys & Games
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Pourquoi ?
modèle print-in-place
Print-in-place
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

LoboCNC publie également sur

313 modèles supplémentaires sur 1 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection