MakerWorld
Hueforge & Lithophane
Zum Modell
Alien Xenomorph Hueforge
71
Downloads
44
Likes
28
Makes
Do NOT adjust the thickness (Z) in your slicer!! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness. These were my settings and colors for my print that you see in the picture. Your results may vary depending on the filament you use and if you have your own HueForge profile saved with different settings. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm I used Elegoo and 3DPower PLA. Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Gray At layer #12 (1.04mm) swap to Silver At layer #16 (1.36mm) swap to Jade White for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!