Slicer Discord
Alienware M17 Cord Clip – 3D-printbaar model van MakerWorld MakerWorld
Electronics

Alienware M17 Cord Clip

door Will · Electronics
10 Downloads
2 Likes
6 Makes
Model downloaden
Original designer made an awesome clip for the Alienware M15 laptop DC cord. I created based their reddit post and increased the DC cord hole size and height so it fits on the M17 laptop. Notes: I replaced my charger, so I'm not positive if this DC end is exactly the same as OEM.To install, start with the lower lip then slide the upper lip into place. Work the DC plug into the receptacle. I had to move the clip slightly off of the computer to get the plug through the hole, then push the plug into the jack and set the unit flush with the computer. It's not perfect, but it does the job!
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Will publiceert ook op

192 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie