Alienware x14 Stand Dock

**Alienware x14 Stand**

I use 4 monitors at work and wanted a docking station stand I could just drop my x14 into. I use a WD19TB Docking station at work. This has been working great for the past 3 months.

**Legs**
Made these with venting in mind which is why there is a big hole where the laptop sits. I don't have any issues with overheating. The smaller holes in the back were to potential run wires for an RGB strip.
- Choose between the Alienware Logo or No Logo
- Print with the logo side up, and crossbar insert on the bottom
- Print one normally, and the other one using the mirror option
- Tree supports in Cura.
- Feel free to test without supports.
- Don't use full supports it will be too hard to remove it from the vent hole

**Crossbar**
The cutouts for the usb-c thunderbolt ports were made to be tight fitting for the Dell WD19 Docking station cable. I made the HDMI cutout bigger using a fatter cable I have. I don't' use the other ports but I made holes ju