全能靶箱/All-purpose target box

     打印了很多射击类玩具了，每天家里小朋友打的小软弹、飞盘弹、BB弹到处是很苦恼，没有找到一个合适练习射击同时又类似子弹的收集器盒子的多功能靶子，于是设计了此模型。考虑到我手里A1mini的大小，以及避免过多的耗材消耗，最终设计为180mm以内的尺寸。（或者你可以放大打印😄，但不建议缩小那样他会很脆弱）     A lot of shooting toys have been printed. Every day, the small soft bullets, flying disc bullets, and BB bullets that the children at home shoot are everywhere, which is quite annoying. I haven't found a multi-functional target that is suitable for practicing shooting and also serves as a collector box similar to bullets. So, I designed this model. Considering the size of the A1mini in my hand and to avoid excessive consumption of materials, the final design size is within 180mm. (You can print it enlarged 😄, but it is not recommended to print it reduced as it will be very fragile.) 完整模型很简单5个部件组成：      1、靶仓：仓内底部设计了坡度，如果是BB弹类的圆形弹丸可从仓口自动滚出。               仓内设计了前后两套靶杆孔位，可根据自己射击器强度需求选择靶杆插前面或者后面一对孔（力量强建议插后面），孔内有凹槽设计可以卡住靶杆。      2、靶子：直面冲击力最大，如果你的射击器力量很大建议最少PETG打印，或者考虑TPU😄。（有多色打印配置可选）      3、靶杆：一边先插入靶仓小圆孔，然后穿上所有靶子零件最后从靶仓另一边孔穿出，靶杆两端设计有凸点与靶仓凹槽对应卡住即可。      4、前面板：卡入靶仓前面槽位胶水固定即可，有一定的防止子弹反弹，以及很好的装饰性。（有多色打印配置可选）      5、弹仓：插在靶仓口收集BB弹类球形子弹或者飞盘子弹，软弹无法装入。 The complete model is simple and consists of 5 components:     1. Target magazine: There is a slope designed at the bottom of the magazine. If it is a round projectile like a BB bullet, it can roll out of the magazine opening automatically. There are two sets of target rod hole positions, front and back, designed inside the magazine. You can choose to insert the target rod into the front or the back pair of holes according to the strength requirement of your shooter (it is recommended to insert it into the back holes if the power is strong). There are groove designs in the holes to hold the target rod.     2. Target: It faces the greatest impact force. If the power of your shooter is very strong, it is recommended to print it with at least PETG, or consider TPU 😄. (There are multi - color printing configurations available.)     3. Target rod: Insert one end into the small roun