Thingiverse
Alliance Symbol
par Apex-3D
11
Téléchargements
9
Likes
0
Makes
-Printed with the Creality CR-10 @ 0.2mm Layer Height
-Top/Bottom Layers - 3 each
-Did not use any support
-Used Brim for Build Plate Adhesion with 5 lines
-Print speed was 60mm/s
-This model can be scaled as needed on any axis
-The model I printed was scaled down from 15mm on the Z-axis to 5mm with no adverse effects during printing.
-The infill was set at 10% but can be any desired amount.
-Print time was approximately 2h 11min
-Top/Bottom Layers - 3 each
-Did not use any support
-Used Brim for Build Plate Adhesion with 5 lines
-Print speed was 60mm/s
-This model can be scaled as needed on any axis
-The model I printed was scaled down from 15mm on the Z-axis to 5mm with no adverse effects during printing.
-The infill was set at 10% but can be any desired amount.
-Print time was approximately 2h 11min
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
