Almost-impossible-3D-test-print

This print will put your slicer and printer to the limit.

Tripple Bridge Block

It’s hard for the slicer to figure out how to slice this right.
It is possible to make the bridge test, but no slicer iv tested have
made this right, it is however very easy to print this with support..
But that’s cheating :)

Don’t expect this to work nice, no slicer av tested have managed to
fix this. This is for the future or with a bridge.


45 deg print

To print with 45 deg without support can be done with almost all 3d printers.
Whats makes this more difficult to print, is that it has to make a “jump”
when it prints in 43 deg, and NOT hit the roof beneath it, no filament or stringing
can touch the roof of the hangar :) This is doable with most slicer and filament, right?

If not, check that you are printing with enough speed and not too high temperature
too high temperature makes your filament to “sink” too fast, and bridging is not possible.


Smooth surface

The pit, ba