Alternate Pegboard Pin

This is a remix of NerdAlert3d's pegboard pins for use with his designs on 3/16 inch thick board with 1/4 inch holes.
https://www.thingiverse.com/thing:1394157

I really liked his system using push pin inserts rather than attached 'hooks' that require print supports (and usually sanding / filing to fit). However, those original pins didn't provide any resistance and ended up sliding right out of my particular pegboard.

This alternate design flexes enough to get through the holder and board holes while sill providing enough resistance to not just slide out. Sized to fit snugly without a whole lot of give.