Alternative hozi Axis

Alternative Axis for Ggrips (by hozi)

hozi made a fantastic alternative grip for the T16000.

my idea was to use the part for my own joystick

many thanks hozi

---

Type_B is now for side stop on both side

---

Technik:

The spring (https://www.federnshop.com/en/products/torsion_springs/t-16737l.html) is relative strong but for that it doesn't wobble.

end stops at 30° on both sides.

at the spring ends I recommend either a hard plate as a base or for PLA prints, or other printing material.

a spring made of 1.2mm wire would be ideal, but this is not available in an inner diameter of 16mm.

14.2mm would be the next one but I haven't tested it yet (https://www.federnshop.com/en/products/torsion_springs/t-18726l.html)

when cutting the feather, be careful not to cut too much, you need something else to bend.

both potis or hall sensors can be used.

I use a standard poti 100K (https://www.conrad.de/de/p/potentiometer-service-rv16af-20-15k-b100k-dreh-poten