Thingiverse
alternator
von dominik01355
1
Downloads
0
Likes
0
Makes
Rotor for alternator replacement with permanent magnet.
Size corresponding to stator parameters.
Glue 40x8x5mm magnets sequentially and alternately N-S-N-S and sequentially...
Dimensions: 47mm/90mm
Hole diameter 14mm
Material PETG 1.75
Density 2mm
PRINT:
Lower relative to the table surface by 2mm to eliminate the base, obtaining an equal 45mm size9 of the object.
Size corresponding to stator parameters.
Glue 40x8x5mm magnets sequentially and alternately N-S-N-S and sequentially...
Dimensions: 47mm/90mm
Hole diameter 14mm
Material PETG 1.75
Density 2mm
PRINT:
Lower relative to the table surface by 2mm to eliminate the base, obtaining an equal 45mm size9 of the object.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!