Aluminatus Corner Clamps

These corner brackets won't allow your build plate to slide around. Or become unlevel once the clamps are tightened.

8x M3x0.5-16lg screws and hex nuts are needed to complete a full set of corners.

Corner parts:
Corner_brkt_v3 - Used when you have ThorLabs Fine Adjustment Screws installed.
Corner_brkt_v4 - Used with leveling shims, or use provision for installing an M3 set screw in the hole nearest the corner.

Clip Parts:
F-300, A-300, F-305, A-305.

The F parts are intended to be fastened and act as stops. put them on the back edge and one side of the build surface.
The A Parts have clearance that allows them to adjust to the edge of the build surface, and go on the sides opposite the F parts.

300 and 305 go with either 300 mm or 305 mm square build plates respectively.

When tightening the A parts, only finger tight is needed. Two fingers on the shaft of the hex key is enough. Too tight can cause the build plate to bow.

Even with finger tight, it can